Street Guardian SG9663TD, Руководство пользователя

Страница: 6 / 30

1. Select a suitable mounting location, if using the adhesive mount
ensure the window is clean prior to application, remove the backing
tape and press and hold the bracket firmly against the glass for 2
minutes, then wait 20 minutes before attaching the camera. The
adhesive will achieve 50% bond after 20 minutes, 100% bond is
achieved after 72 hours, if the camera is attached to the bracket too
soon after installation the adhesive may not bond correctly.
[Note] When determining the mounting locations be sure to leave
adequate room to be able to detach the cameras.
2. Fix the power, (optional) rear camera, and GPS cables properly and
route cables across the passenger side where possible to prevent the
line of sight from being affected.
[Note about optional rear camera] Prior to installing the rear camera
cable determine the most suitable routing for the cable for your
installation type, with all cable routing it is important to take note of
any pillar or side curtain airbags, cables must be installed so as not to
interfere with the operation of these safety systems, if in doubt
please seek professional installation.
3. Insert the charging interface of the in vehicle charger into the USB
interface of the DVR.
4. Connect the GPS and position the cables accordingly, the GPS
should be mounted with the adhesive side to the windscreen so that
the antenna is oriented correctly.
Your camera is supplied with an on glass GPS antenna, an optional
dash top GPS antenna is also available. The GPS should be mounted
correctly according to which type of GPS antenna is in use.