Strebel S-ASX 30, Руководство по установке, эксплуатации и техническому обслуживанию

Страница: 19 / 74

19
5.2 Additional Options
Depending on the installation requirements , we can provide additional options to be installed within the appliance casing
to facilitate. These options will need to be ordered with the appliance so that they can be fitted in our factory on building
the appliance.
Item Description
High Head System Pump
Allows the circulation of the water on the system side of the heat pump to the thermal
/ buffer vessel with a higher available head.
Internal DHW 3 Way Valve
Allows to divert the hot water produced by the heat pump from the heating circuit to
the domestic hot water circuit.
NTC Temp Sensor 10K
Required for a DHW circuit to monitor the DHW temperature within cylinder.
AVS 75.370 Extension
Module In case additional relays are required for installation requirements. An additional two
modules can be added in total per heat pump controller.
5.2.1
S
YSTEM
S
IDE
I
NTERAL
P
UMP
S
ETUP
E
XAMPLE
–
M
ODULATING OR
H
IGH
H
EAD
The location of the system pump is located where the black arrow is pointing to.
5.2.2
I
NTERNAL
3 W
AY
V
ALVE
E
XAMPLE
–
DHW P
RODUCTION
The location of the DHW 3 way valve is located where the black arrow is pointing to.
5.3 Accessories
Item Description
External DHW 3 Way Valve Instead of an internal valve, this can be mounted external within the plantroom.
Coil Protection Grills Protect the external surface of the finned coil.
Rubber Vibration Dampers Reduces the transmission of vibration to the surface and to reduce noise levels.
Adjustable Rubber Vibration
Dampers
As above
– the height can be adjusted to fit uneven ground.