Strautmann Sherpa 120, Руководство по эксплуатации, Страница: 193 / 209

Service and maintenance
Sherpa 120, 140 | 06.19 193
9.25.4 Turn over or replace milling blades
Operative staff:
•
Qualified staff
CAUTION
Sharp-edged milling blades
Risk of cuts.
•
Wear cut-proof protective gloves.
•
Cover the milling blades by means of an edge protector.
The drum is divided into:
R = right-hand vehicle side
L = left-hand vehicle side
NOTE
The knives are fitted with two blades each, only one of which
is in gear. If the active blade is blunt, the knives of the left-
hand vehicle side may be interchanged with those of the right-
hand vehicle side and vice versa. This means:
–
Milling blades worn on one side can be turned over.
–
Milling blades worn on both sides must be replaced.
Replace the locking nuts during each new installation of
knives, as otherwise the locking effect of the nuts no longer
exists.
Fig. 157
1. Open the milling drum guard.
2. Secure the machine against accidental starting and
rolling.
3. WARNING
– Risk of crushing to limbs due to
unintentional lowering. Secure the pick-up arm and the
protective device against lowering.
4. Carefully turn the milling drum by hand and check the
condition of the milling blades.
5. Retighten the screwed connections of loose milling
blades.
6. Replace worn milling blades.
–
Unscrew the milling blades (1).
–
Replace the milling blades with new ones or
interchange the milling blades of the left-hand and
right-hand side of the milling drum.
Fig. 158