Strautmann Giga-Vitesse CFS 3602, Руководство по эксплуатации

Страница: 108 / 327

Commissioning
Giga-Vitesse CFS 3602 - 4402, Giga-Vitesse CFS 3602 DO - 4402 DO 03.18 108
5.9.2 Set additional guide wheels
The height and the load-bearing capacity of the additional guide
wheels are set by means of the spindle:
•
Spindle unscrewed = Additional guide wheels carry more
weight
•
Spindle screwed in = Additional guide wheels carry less weight
1. Set the operating height of the pick-up via
the left-hand and right-hand pick-up
perforated strut (2).
2. Lower the guide wheels (4) of the pick-up
onto a solid, even surface.
3. Secure tractor and machine against
accidental starting and rolling.
4. Set the height of the additional guide
wheels (5) via the left-hand and right-hand
spindle (6) such that the guide wheels bear
the largest load.
For this purpose, align the frame (5) of the
additional guide wheels via the two
spindles such that the additional guide
wheels are set by 10-20 mm higher than
the guide wheels.

Remove the linch pin (6).

Use one hand to hold up the frame,
while using your other hand to turn
the spindle.

Use the linch pin to secure the
spindle.
Fig. 56
5. Completely lift the pick-up.
The frame must be beneath the check
screws (7). The minimum distance
between the additional guide wheels and
the CFS drum must be 10 mm. Adjust the
distance if necessary.
Fig. 57