STRATUS Floor Plate 2 post Lift Installation & Operation & Maintenance Instructions
10
4. Safety
4.1 Important notices
This 2-posts lift is specially designed for lifting motor vehicles that weighs within its outmost lifting capacity. Users
are not allowed to use it for any other purposes. Otherwise, we, as well as our sales agency, will not bear any
responsibility for accidents or damages of the lift. Make sure to pay careful attention to the label of the lifting
capacity attached on the lift and never try to lift cars with its weight beyond.
Read this manual carefully before operating the machine so as to avoid economic loss or personnel casualty
incurred by wrong operation. Without professional advice, users are not permitted to make any modification to the
control unit or whatever mechanical unit.
4.2 Qualified personnel
➢
Only these qualified staff, who have been properly trained, can operate the lift.
➢
Electrical connection must be done by a competent electrician.
➢
People who are not concerned are not allowed in the lifting area.
4.3 Danger notices
➢
Do not install the lift on any asphalt surface.
➢
Read and understand all safety warnings before operating the lift.
➢
The lift, if is not special
ly designed upon customer’s request, is not fit for outdoor use.
➢
Keep hands and feet away from any moving parts. Keep feet clear of the lift when lowering.
➢
Only these qualified people, who have been properly trained, can operate the lift.
➢
Do not wear unfit clothes such as large clothes with flounces, tires, etc, which could be caught by moving parts
of the lift.
➢
To prevent evitable incidents, surrounding areas of the lift must be tidy and with nothing unconcerned.
➢
The lift is simply designed to lift the entire body of vehicles, with its maximum weight within the lifting capacity.
➢
Always ensure the safety latches are engaged before any attempt to work near or under the vehicle.
➢
Make sure to place the lifting pads to the positions as suggested by vehicle makers and when gradually lift the
vehicle to the desired height, operators should be certain that the vehicle will not slant, roll-over or slide in lifting
process.
➢
Check at any time the parts the lift to ensure the agility of moving parts and the performance of synchronization.
Ensure regular maintenance and if anything abnormal occurs, stop using the lift immediately and contact our
dealers for help.
➢
Lower the lift to its lowest position and do remember to cut off the power source when service finishes.
➢
Do not modify a
ny parts of the lift without manufacturer’s advice.
➢
If the lift is going to left used for a long time, users are required to:
a. Disconnect the power source;
b. Empty the oil tank;
c. Lubricate the moving parts with hydraulic oil.
4.4 Training
Only these qualified people, who have been properly trained, can operate the lift. We are quite willing to provide
professional training for the users when necessary.
Attention: For environment protection, please dispose the disused oil in a proper way.
