Stratus ftServer V 2302, Руководство по планировке объекта

Страница: 13 / 80

Planning for Cables
Site Planning for ftServer V 2302, V 4304, and V 6308 Systems 1-3
that the system is less fault tolerant, and any I/O throughput distributed between
the enclosures may be reduced. To restore full fault tolerance, an enclosure can be
replaced without taking the system offline.

ftServer systems can connect to the Remote Service Network (RSN).
Connecting a system to the RSN allows the CAC to remotely diagnose,
troubleshoot, and resolve problems online.
Your system connects to the RSN by an AA-E97900 RSN console server connected
either to the Internet or to an AA-C72100 modem. See
“RSN Connections” on page 3-1
for more information.
Planning for Cables
At sites with solid (non-raised) floors, the cables exit from the top of the cabinet and are
routed along the ceiling.
At sites with raised floors, the cables exit from the bottom rear of the cabinet and are
routed under the floor.
To accommodate cables from your system, make sure to provide:

One or two telephone lines as described in “Telephone Lines” on page 4-1 :

Ethernet ports, switches, or hubs, as needed

Two UPS units, within reach of the power cords from the system or PDUs

For external components, AC wall outlets within reach of the power cords from the
components
Make sure that cables you plan to connect to the system are long enough to reach
between the system and external components or connections. For information about
specific cables and power cords, see the following:

“Power Cord Summary” on page 2-6

Chapter 3, “Space and Component Location Planning”

Stratus ftServer Systems: Peripherals Site Planning Guide (R582) for information
about cable lengths for peripheral components