Stratasys uPrint, Руководство по обслуживанию, Страница: 77 / 383

4-30
7.
Using a Phillips screwdriver, remove the 3 mounting screws from the I/O card. See
Figure 4-53.
Figure 4-53: I/O card mounting screw locations
8.
Gently pull the I/O card out from the power distribution board sockets.
Installing the I/O card
1.
Gently slide the I/O card in to the power distribution board sockets.
2.
Verify the I/O card is seated properly by viewing the connection through the viewing
slots. See Figure 4-54.
Figure 4-54: I/O card viewing slot location
3.
Using a Phillips screwdriver, reinstall the 3 mounting screws.
4.
Reconnect the thermocouple to the back side of the I/O card.
5.
Reconnect the 6 cables to the I/O card.
6.
Close the electronics bay. See Closing the electronics bay on page 4-16.
7.
Reinstall the side panels. See Installing the side panels on page 4-8.
8.
Reinstall the top panel. See Installing the top panel on page 4-6.
Remove the 3
mounting screws
I/O card
connections