Stratasys uPrint, Руководство по обслуживанию, Страница: 66 / 383

uPrint/uPrint SE Service Manual 4-19
Removing the Electronics Bay
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver.
Hardware
• 10-32 x
1
⁄
2
” slotted screws (x8)
Removing the electronics bay
1.
Remove the top panel. See Removing the top panel on page 4-5.
2.
Remove the side panels. See Side Panels on page 4-7.
3.
Remove the upper electronics bay cover. See Removing the upper electronics bay cover
on page 4-17.
4.
Touch the metal plate of the electronics bay cover to discharge any static electricity.
5.
Disconnect the 6 I/O card cables by pressing down on the long tabs and pulling out. See
Figure 4-37.
6.
Disconnect the chamber thermocouple wire. See Figure 4-37.
Figure 4-37: I/O card cable locations
7.
Remove the left and right side electronics bay mounting screws with a
5
⁄
16
” nut driver or
standard screwdriver. See Figure 4-38.
I/O Card cable
locations Chamber thermocouple
wire location