Stratasys uPrint, Руководство по обслуживанию, Страница: 50 / 383

uPrint/uPrint SE Service Manual 4-3
Maintenance Preparation
Read these warnings before performing service on printer!
Warning: Make sure the power is disconnected when performing any of the
disassembly or assembly instructions in this chapter. Failure to do so can cause
severe personal injury or damage to the electronics.
Warning: Servicing instructions outlined in this chapter are intended for use by
qualified personnel only. Failure to follow these guidelines can cause severe
injury.
Warning: The Power Switch does NOT remove power from the printer. The
Breaker Switch located on the rear of the printer MUST be off before service is
performed on the printer. It is recommended that the AC power cord be
disconnected before performing maintenance outlined in this chapter.
Warning: Use extreme caution when the door solenoid is disabled. Axes may
move unexpectedly, which may cause serious injury. Always remember to
enable the door solenoid once service is completed.
Note: All references within this procedure to ‘Left’ or ‘Right’ are made
assuming that the printer is being viewed from the ‘Front’ (the door and user
interface panel side).