Stratasys uPrint, Руководство по обслуживанию, Страница: 45 / 383

3-10
Part Calibration
Temperatures
The temperature control dialog allows you to adjust the set points for the head and chamber
temperatures, for both modeling and at standby.
Temperature Setpoints
Outputs
The outputs dialog contains toggle buttons to control solenoids and motors that can not be
directly controlled on the Control Panel Display.
Table
Table calibration consists of downloading the correct XY table calibration file to the machine
to properly adjust for table-to-table tolerance issues. The Table dialog allows you to browse
for and select the calibration file for the currently installed XY table and to download it to the
machine.
Left
Measured on left side of modeling base, front to back.
Right Measured on right side of modeling base, front to back.
Front
Measured on front side of modeling base, left to right.
Back Measured on back side of modeling base, left to right.
Left Front
Measured from front left corner to rear right corner.
Left Rear Measured from front right corner to rear left corner.
Item Build Setpoint Standby Setpoint
Model 300 102.5
Support 300 102.5
Chamber 75 75
Model Latch
The check box shows the state of the model (top) cartridge latch, and the toggle button
changes that state.
Motor Enabled
The check button shows the state of the model (top) feed motor solenoid, and the toggle but-
ton changes that state.
Motor Running
The check box shows the state of the model (top) filament feed motor, and the toggle button
changes that state.
Support Latched
The check box shows the state of the support (bottom) cartridge latch, and the toggle button
changes that state.
Motor Enabled
The check box shows the state of the support (bottom) feed motor solenoid, and the toggle
button changes that state.
Motor Running
The check box shows that state of the support (bottom) filament feed motor, and the toggle
button changes that state.
Door Latch
This check box shows the state of the door latch solenoid, and the toggle button changes that
state.
Lights On
This check box shows the state of the chamber lights, and the toggle button changes that
state.