Stratasys uPrint, Руководство по обслуживанию, Страница: 44 / 383

uPrint/uPrint SE Service Manual 3-9
Setting the Serial Number
To set the system serial number enter the serial number in the “Product Serial Number” field
and click on the green check mark. The serial number displayed in this field is the current
serial number of the product.
Materials
Every cartridge has a SmartSpool EEPROM attached that tracks information about the
filament remaining on the cartridge, and shelf life information. The following information is
provided for each cartridge. The top cartridge is the Model material cartridge, and the
bottom cartridge is the Support material cartridge.
Cartridge Information
Tip Offset
The tip offset control dialog allows you to adjust the tip offset values.
Gantry
The gantry controls the adjustment for the XY gantry. These values are set in the factory and
do not need to be adjusted unless the XY gantry is adjusted or replaced.
Gantry Hysteresis
Serial Number
This is a unique number assigned to each cartridge.
Material Type This is the type of material on the cartridge. For example:
P400 - is a standard modeling material
P400R - is a standard release material.
P400SR - is a standard soluble release material.
Manufacturing Lot
This is a lot code used by Stratasys to control the manufacturing process.
Manufacturing Date
This is the date that the cartridge was manufactured.
Use Date
This is the date that the cartridge was first inserted in a machine.
Initial Quantity
This is the amount of material that was on the cartridge initially.
Current Quantity
This is the amount of material currently on the cartridge.
Tip Offset X,Y
XY distance from model tip to support tip.
Z Tip to Base
Depth of tip into modeling base.
Z Tip to Tip
Z distance from model tip to support tip with desired offset.
Y Lash
Mechanical lash is the tendency of the gantry to remain stationary after a change in direction until the
mechanical slop in the system is taken up by the move.
X Adjust
X Axis adjustment provides a method of removing additional linear part error that is present in the XY
Gantry after assembly.