Stratasys uPrint, Руководство по обслуживанию, Страница: 377 / 383

9-4
XY Table Assembly Installation Checklist
If you have any questions before or during installation, do not hesitate to call your Customer
Support provider.

Replace the XY table Assembly.

Verify that all electrical leads are connected correctly

Perform the XY Leveling procedure

Check/Adjust the X-Drive Belt tension

Check/Adjust the Y-Drive Belt tension

Manually move the table in both the X and Y direction to ensure it moves smoothly.

Clean and vacuum the system.

Power system up and verify that system homes correctly.

Load material.

Perform the Part Based Calibration procedure.

Perform the Z Calibration and XY Offset Calibration.

Unload material.

Remove the system CD from the electronics bay and discard.

Using MaracaEX select “Get” to send the .cal file from the system to a new blank CD. Place
the new CD in the electronics bay and secure the rear door.

Load material.

Run a small test part to ensure part quality is acceptable and that the XY table is functioning
correctly.

Discuss with the customer any questions or issues they may have.

Pack the old XY table into the shipping box along with the RMA documentation and ship
back to Stratasys.