Stratasys uPrint, Руководство по обслуживанию, Страница: 215 / 383

5-6
Entering XY Tip Calibration values manually (Firmware version 9.1 or newer)
XY Tip is the XY distance from model tip to the support tip. To move support roads to the
right (+X), apply a positive offset. To move support roads to the back (+Y), apply a positive
offset. If the calibration model is too far off to read, these values may be set to default as a
starting point for calibration. The default values are X: 0.780” and Y: 0.000”.
1.
While the printer is at
Idle
, enter standby mode by pressing the
Standby...
button.
2.
Enter the Service Calibration menu by pressing the following button sequence on the
display panel:
3,2,3,3,1
. See Figure 5-280.
Figure 5-280: Service Calibration button sequence
3.
Press the
Edit Configuration
button.
4.
Press the
Next...
button.
5.
Press the
Next...
button.
6.
Press the
XTIP
(X tip offset) button.
7.
Enter the calibration value by pressing the
Increment
,
Decrement
and
Next Digit
buttons.
8.
When finished, press
Done...
9.
Press the
YTIP
(Y tip offset) button.
10.
Enter the calibration value by pressing the
Increment
,
Decrement
and
Next Digit
buttons.
11.
When finished, press
Done...
12.
Press the
Next...
button until you reach the last page.
13.
Press the
Done...
button.
14.
Press the
Save and reboot
button.
15.
The printer will reboot and return to idle.
Note: The value for XTIP must be between 0.7300” and 0.8300”. For example, the
value from Figure 5-279 is + 2, you would increment the current value by
+0.002”.
Note: The value for YTIP must be between -0.0500” and 0.0500”. For example, the
value from Figure 5-279 is - 4, you would decrement the current value by -0.004”.
Button 0
Button 1
Button 2
Button 3