Stratasys J750/J735/J720 User Guide
4 Operating and Maintaining the Printer
DOC-08040 Rev. R
4-102
13. Use the UV lamp clamp to insert the lamp into place in the UV reflector.
Figure 4-153 Pushing the UV lamp into place
14. Using a 2.5-mm hex key, secure the clamp to the UV reflector, and continue
with step
25
.
Figure 4-154 Attaching the UV lamp clamp
15. Inspect the new UV reflector, and make sure that a black strip is attached to
the inside of it. If not, install one—on the side of the reflector
opposite
(not
next to) the print block.
Note:
Extra black strips are included in the printer Start-Up Kit. If necessary,
you can remove the black strip from the old reflector and install it in the new
reflector (as long as the black paint has not faded).
16. Discard the old UV reflector and lamp.
Dispose of the used UV lamp in accordance with environmental and safety
requirements.