Eden260V User Guide
6 Operating and Maintaining the Printer
DOC-32020 Rev. F
6-48
Installing the New Head
13.Inspect the replacement head, and make sure that the O-ring seals are in
place (see Figure 6-63 on the previous page).
14.Gently insert the replacement head into the vacant slot in the print block, and
push the print-head driver card into its socket.
Note:
Make sure to insert the head with the driver card facing its socket, in
the rear of the print block.
Figure 6-65 Inserting the print-head driver card into its socket
15.Push the head up until you hear it click into place, in both front and rear
holders.
Figure 6-66 Clicking the head into place in the print block
16.Lower the door of the print head compartment, and tighten the screws to lock
it in place.
17.Tighten the upper and lower screws that secure the print head in the print
block (see Figure 6-59 on page 6-45).
Note:
Hand-tighten only! Do
not
use tools to tighten these screws.
