Stratasys Eden250, Руководство пользователя

Страница: 96 / 122

Operating & Maintaining the Eden 3-D Printer
7–20
DOC- 22000 Rev. A
11. Select the confirmation check boxes in the wizard screen and click
Next
.
Figure 7-27:Wiper Cleaning procedure—final screen
12. Click
Done
to close the wizard.
Aligning the
Printing Heads
You should check the alignment of the printing heads—
•
once a month
•
after replacing one or more heads
•
if model quality is not acceptable even after cleaning the orifice plate on
the bottom of the print block (see “Cleaning the Printing Heads” on
page 7 ‐ 14)
The head ‐ alignment procedure takes about 20 minutes.
To check the alignment of the printing heads:
1. Prepare—
•
an A4 ‐ size transparency sheet
•
any type of sticky tape, to fasten the transparency sheet to the build
tray
2. Start the Head Alignment wizard, either from the Wizards tab (on the
right side of the Eden interface) or from the Eden Options menu (see
figure 7 ‐ 24 on page 7 ‐ 18).
3. Click
Next
to begin, and close the cover.
4. In the wizard screen, select the check box to confirm that the cover is
closed, and click
Next
.