Installing and Using the Blood Vessel Cleaning Apparatus Kit (Optional)Removing the BVCA Cleaning Fixture
Page 34
© Copyright 2019 Stratasys. All rights reserved.
Stratasys Confidential
Removing the BVCA Cleaning Fixture and Inserting the
Cleaning Basket
You can use the regular cleaning basket in the CSIIP cleaning station without removing the
BVCA jet plate.
1. Remove the safety cover (see
“Securing the Safety Cover” (page 30)
2. Remove the cleaning tray using the tray handles.
3. Push the button on the water supply connector, shown in
, and slowly raise the
manifold to remove the manifold from the tank.
4. Remove the filter basket at the bottom of the tank by lifting the lever on the side of the filter
basket.
5. Remove the 2 cover hold-down bracket nuts, and remove the bracket.
Figure 29: Cover hold-down bracket nuts
6. Place the jet-plate cover, supplied in the kit, over the 2 screw studs, and tighten the nuts.
Figure 30: Jet-plate cover
Caution:
Lift the BVCA cleaning fixture only by the manifold and frame. Do not lift the BVCA
cleaning fixture by the pressure gauge on the manifold, as it may damage the
pressure gauge.
Cover hold-down
bracket washers
and nuts
Jet-plate
securing screws
Cover hold-down
bracket screws