Strata CIX 200, Руководство по программированию

Страница: 31 / 508

Strata CIX Programming Guidelines
Use Default Auto-programming to Start Up
Strata CIX Programming Vol.1 12/09
1-11
St
ra
ta
C
IX
Pr
og
ram
m
in
g
Default Feature Access Codes
Refer to ”102 Flexible Access Codes’ on page 4-3 .
Note For DKT and IP telephone, assign only the PDN. Do not program any other Flexible Buttons or
features in the phones. Strata CIX recognition and setup is automatic for these telephones.
Plan Your System Requirements
Plan your Strata CIX system requirements in detail before beginning your installation. The following are
some areas to consider:
• Flexible Numbering Plan (102) – Planning your Flexible Numbering requirements is essential to a
smooth installation. Trunk group access and station range requirements are especially important areas
of consideration.
• COS (103) – Determine the Class of Service (COS) requirements for your station and trunk groups.
There are up to 32 possible COS plans.
• DRL (111) – Define up to 16 Destination Restriction Level (DRL) assignments.
Important! Destination Restriction is an expanded feature of what has traditionally been known as Toll
Restriction. Toll Restriction is only one facet of Strata CIX’s Destination Restriction feature.
Refer to Destination Restriction in this manual when programming Toll Restriction
requirements.
• FRL and QPL (506) – Define up to 16 Facilities Restriction Level (FRL) and Queuing Priority Level
(QPL) assignments.
Program the CIX for First Time
Follow these steps to program the CIX for the first time. Following this initial setup procedure enables you
to perform a Strata CIX setup with common System and Station default assignments. Toshiba
recommends adherence to these procedures for initial setup. Refer to the CIX40 Installation and
Maintenance Manual (CIX-IM-CIX40-Vx) for the CIX40 default database and start-up procedures.
1. Card Assignments (100) – Choose System > Card Assignment. It is not necessary to physically install
PCBs prior to programming the Strata CIX.
If you physically install your PCBs prior to initial setup, Strata Network eManager automatically
recognizes PDKU, BDKU/BDKS, RSTU, RCOU/RCOS and RGLU PCBs and assigns default stations
and trunks automatically. All other PCBs are assigned manually. See
”100 Cabinet Slot PCB
Assignments’ on page 4-1 for more details.
2. ILG Assignment (304) – Choose Trunk > ILG to assign Incoming Line Groups (ILG). See ”304, 305
Incoming Line Group’ on page 6-1 for more details. ILGs enable line groupings of shared Class of
Service features for incoming call handling.
3. OLG Assignment (306) – Choose Trunk > OLG to assign Outgoing Line Groups (OLG). See ”306, 307
Outgoing Line Groups’ on page 6-5 for more details.
4. Trunk Assignment (300) – Choose Trunk > Trunk Assignments and click the Basic tab. Set up your
trunks in the following order (see ”300, 301 Trunk Assignment’ on page 6-7 for more details):
- Loop Start Trunks
- Ground Start Trunks
- T1 Trunks
- Tie lines
- FX lines
- PRI lines
- BRI lines