STOVES 600GR, Руководство пользователя и инструкция по установке

Страница: 23 / 34

Step 1: Prepare installation
Do not lift the appliance by the
door handle.
Whilst every care is taken to eliminate
burrs and raw edges from this product,
please take care when handling - we
recommend the used of protective
gloves during installation.
Please note that the weight of this
appliance is approximately
31kg
(unpacked). Take care when lifting it
into the housing unit - always use an
appropriate method of lifting.
Remove the fixing screws from the
polythene bag on the top of the
appliance, but leave the appliance in
the base tray packaging until you are
ready to install it.
If this appliance is to be installed near
to a corner where the adjacent
cabinets run at right angles forward of
the appliance, there must be a gap of
at least 90mm between the appliance
and the cabinets, to prevent overheating
of the cabinets.
Ensure that the built in unit is
appropriately fixed to the wall.
•
When installed in a typical
600mm deep built in housing unit,
the false back should be removed
from the housing unit, to provide the
necessary depth for installation.
• When the false back is removed, it
is normally the case that the support
shelf for the appliance leaves a
gap between the back edge of the
support shelf and the rear wall of
approximately 80mm.
• If no gap occurs between the
back edge of the shelf and the
wall behind the unit a gap of at
least 30mm MUST be made by
shortening the shelf.
• When fitted below a worktop a
gap of 12mm must be made
between the top of the plinth and
the underside of the support shelf
for the appliance.
Important: Do not modify the outer
panels of this appliance in any way.
21
INSTALLATION INSTRUCTIONS
90mm (minimum)
support
shelf
M
in
3
0
m
m
g
a
p
r
eq
ui
re
d
a
t
b
a
ck
o
f
su
p
p
o
rt
s
he
lf
This space behind
the appliance must
be kept clear
Re
a
r
w
a
ll
12mm air gap
in top of plinth