15
14
If the preceding tips do not
yield the desired results, or for
any other defects or problems
not mentioned here, please unplug the
power adapter and contact our Service
Center immediately.
Do not open the Vaporizer or
the power adapter! Without
special tools and specialized
knowledge, any attempt to open either
of these devices will cause damage to
them. Such an attempt will invalidate
the warranty claim.
6. TH E C R A F T Y VA P O R IZER
Do not try to remedy the defect your-
self. Contact our Service Center di-
rectly.
Disposal
If the Vaporizer or the power adapter
has been irreparably damaged after
the warranty period, please do not sim-
ply throw them away. As they are made
of high quality, completely recycla-
ble component parts, they should be
brought to a material recycling center
in your town or sent to our Service
Center for disposal.
Possible faults / Troubleshooting
Problem
Possible cause/remedy
CRAFTY cannot be
switched on.
Please ensure that the CRAFTY’s battery is
charged.
If the Vaporizer still does not work, then the device is
faulty. In this case, get in touch immediately with our
Service Center.
The LED display of
CRAFTY
flashes alter
-
nately red/blue.
Battery temperature is either too high or too low.
Allow the hot Vaporizer to cool down or the cold
Vaporizer to warm up.
The LED display of
CRAFTY
flashes blue.
Battery is completely discharged. Please connect
the charger.
The LED display of
CRAFTY
flashes alter
-
nately red/green.
The power adapter or the USB cable is not suitable.
Please use an original Storz & Bickel power adapter
and USB cable or 12 Volt car charger.
The LED display of
CRAFTY
flashes alter
-
nately red/orange.
The Vaporizer is faulty. In this case, disconnect from
the mains without delay and get in touch immedi-
ately with our Service Center.
6. TH E C R A F T Y VA P O R IZER
Power Connection
Before connecting up the Vaporizer,
make sure that the information given
on the power adapter type label cor-
responds to the local power supply
voltage.
All parts of the electrical system must
comply with currently applicable offi
-
cial regulations.
Place the heated Vaporizer only on a
hard, stable surface, and not on any
soft or heat-sensitive material.
Take care that the power adapter USB
cable cannot be damaged through
kinking, crushing or pulling.
Improper installation may lead
to personal injury or material
damages, for which the manu-
facturer cannot be held responsible.
Application and Operation
This Vaporizer was developed
for vaporizing the plant materi
-
als listed in the plant overview.
Any other use is inappropriate and po-
tentially dangerous.
The user should always follow the in-
structions listed here for use and main-
tenance.
If you have any concerns, or if there are
any problems immediately switch off
the Vaporizer and pull the power adapt
-
er cord, if used, from the socket. Do not
try to remedy the defect yourself. Con-
tact our Service Center directly.
After using the Vaporizer and power
adapter, allow them to cool down be-
fore placing them in storage.
Storage
Store the Vaporizer and the power
adapter in a dry place protected
against the effects of weather and out
of the reach of children or unqualified
persons.
In Case of Problems
If the power adapter has been in use,
unplug it at the socket and ensure that
no one can connect the Vaporizer to
the mains supply again without this
being noticed.
Before any maintenance work is done,
the Vaporizer has to be switched off
and the power adapter unplugged
from the power supply.
Put the Vaporizer in the original pack
-
aging, or pack it properly in other pack-
ing material, and send it to our Service
Center.
