39
Preface
Reading this instruction manual is the basis for operating the ProCut basic foam board cutter.
Before starting to use the device this instruction manual must be read carefully and in full.
If there is anything you do not understand, contact us immediately.
Do not operate the device if you are in any doubt.
By starting to use the device, you confirm that you have read and understood the manual
and assume the responsibility for its operation.
The methods and procedures used for manufacturing and quality monitoring purposes
correspond to state of the art technology.
Please observe the safety precautions
!
The device possesses a voltage range which can pose an electrical hazard to humans
and animals in the event of certain unfavourable conditions.
It should only be unscrewed and / or disassembled by authorised personnel.
Similarly, maintenance and repair work should only be conducted by electrical
specialists and authorised service centres. The buyer / user operates the device at
their own risk and under their own responsibility.
Area of application
This device is intended exclusively for cutting rigid polystyrene foam (styrofoam).
Operation
This device should only be used by an instructed person who is familiar with its operation.
Use of suitable work clothing and protective gloves is recommended.
(Also refer to the section entitled „Safety precautions“).
If the device is going to be used indoors, it should only be operated in areas that are adequately
ventilated. The device operates with low voltage and it should only be used with the connected
special transformer.
The device should only be operated with the original cutting wire (d = 0.7 mm).
If work is going to be interrupted for more than 3 minutes, switch off the device.
Cleaning and maintenance
Before starting to use the device all nuts and bolts must be checked and re-tightened if necessary.
Wire guide rollers and pullout elements are to be cleaned and checked for free movement.
If it is heavily contaminated (incrustation), the cutting wire must be replaced.
