7
C - ROOF COVER INSTALLATION
NOTE:
DO NOT install the cover onto the frame of your building in high wind conditions. A
slight breeze is the most advantageous for cover installation. To take advantage of the
breeze, pull the cover up over the arches with the breeze blowing in the cover like a sail
filled with air.
1.
Insert the
Lower tensioning tube for roof cover
(part code 7) into the pockets on
the end of the
roof cover
(part code 8). Then put the
∮
32 Plastic plug for base rail
section
(part code 12).
Figure 5
2.
Put the
Roof cover
(part code 8) EVENLY, CAREFULLY AND SLOWLY atop the frame.
Adjust the cover so that it is square and evenly centered on the frame.
Figure 6
3.
On the
Roof cover, c
ut pockets over each ratchet on the base plates, then use the
Ratchet strap
(part code 13) to tie down the
Lower tensioning tubes
.
