Siena Recesso, Lastra and Trucco Installation (#’s SI-IN-36, SI-CS-36, SI-MK-36)
Please read these instructions carefully before you begin. Also, review the recommended tools
section and lay out all components to assure you have the correct tools, items and quantities needed
for proper installation.
Note:
The Siena Collection is designed to be installed on a flat and level surface. Any variation in this will
require the use of shims. It will also add time to the installation.
Caution!
Stone sinks, countertops and vanities are very heavy. Please use care and caution when handling.
Important:
Do not use an oil-based sealer, silicone, or plumbers putty. These products will stain if applied
near the surface. Use a latex-based caulk recommended for use with tile and stone.
All installation procedures must comply with all applicable local plumbing and building codes.
Required tools:
Material Lift
Level
Tape Measure
Rubber Mallet
Drill/driver
5 minute clear epoxy Wood blocks
Short
handled
philips
screwdriver
Additionally for the Recesso Sink, #SI-IN-36:
Adhesive Caulk/Sealant such as DAP Qwikseal
®
or
Henkels Polyseam Seal
®
Supplied parts:
Wood Screws #8 x ¾”L(x6)
Machine Screws ¼”-20 x ¾”L(x18)
