STK Professional Audio VM-8DRV, Руководство пользователя

Страница: 9 / 32

9
4a. EFX(DSP)
The channel EFX(DSP) control varies the amount of channel
signal sent to the D.S.P, as well as to the effects send circuitry
5a. MON
This controls the amount of signal sent from an
individual channel to both the Mon master control.
In addition, this control also feeds the monitor send.
This aux send is a pre channel level control and pre
EQ. This means that the level sent from an individual
input will not be affected by adjustment of the main
channel level control or EQ settings and allows a
completely separate mix for stage monitors.
6a. High
The high frequency shelf control is set at 8kHz.
You can increase or attenuate frequencies 8kHz(and
above)up to 15dB. There is a detente in the 0 position
indicating a flat response.
7a. Mid
The mid frequency is centered at 2.5 kHz.
You can increase or attenuate the midrange
frequencies by as much 12dB. A detente is provided
in the 0 position indicating a flat response.
8a. Low
The low frequency shelf control is set at 80Hz.
You can increase or attenuate frequencies 80Hz(and
below) up to 15dB. A detente is provided in the 0
position indicating a flat response.
9a. Bal
This control varies the amount of channel signal sent
to either the left or right channel of the stereo mixer.
FRONT PANEL MASTER SECTION
11. Aux In
Connect these jacks to he output jacks of an external
effects processor.
If the effects processor has a stereo output,
connect it to the AUX IN L(MONO) and R jacks.
If it has monaural output, use the AUX IN L(MONO) jack.
Signal input to these jacks is sent to the ST bus.
12. Tape In
Use these jacks to connect a stereo device, such as a cassette
player or a CD player. The signals input to these jacks is sent
to the ST bus.
13. Rec Out
The ST bus signal before it has passed through the
MASTER control and graphic equalizer.
14. Monitor Out
The MONI bus signal which has passed through the MASTER
control and graphic equalizer.
15. Left/Main, Right/Mon Out
The Left/Main and Right/Mon output 1/4" connectors are the
final output for the master stereo mix and controlled by the
master left and light controls.
16. EFX Out
The input of an external effect such as a delay or
echo can be connected to this jack. The signal
adjusted by the EFFECT control of each channel
will be sent to the EFFECT bus, its level adjusted
by the EFFECT OUT control , and output from
this jack.
17. Footswitch
The DSP Footswitch jack is a standard 1/4
＂
size
accommodating a monaural ON/OFF Footswitch that
enables/disable the internal digital effects.
18. Mono/Subwoofer
This line level subwoofer output allows you to conveniently add
supplemental buss to your system. The signal is derived from
summed left+right master output or the master output and is
routed through a 125Hz low pass filter
.
19. Aux In /Tape In Control
This control varies the amount of the signal from the
Tape In and Aux In mixed back to the main buss.
20. Aux / Tape to Mon Control
The Aux/Tape to Mon Control provides continuously variable
adjustment of the signal derived from the tapein jacks located
on the connector panel and sends
that signal to the monitor/aux master control.
21. Main Amp Assign (L+R/Bridge, Stereo)
This push button control routes either the main
outputs left & right, through the left and right
graphic EQ section or sends the main mono signal
through the left graphic EQ section and a monitor
mono signal through the right graphic EQ sections.
Panel Descriptions