Still RX60 35-50, Оригинальное руководство пользователя

Страница: 436 / 596

Charging cable
Use only the included charging cable as a
connection between the on-board charger and
the mains socket.
If the charging cable is used, observe the fol-
lowing:
–
Route the charging cable without strong
mechanical load, e.g. tension.
–
Protect the charging cable from mechanical
loads.
Do not allow the charging cable to cross traffic
routes. Do not route the charging cable over
sharp edges.
–
Before you use the charging cable, check
the plugs and the connection sockets for
damage.
–
If any damage is found, do not use the
affected components (this applies to the
charging cable and the charger socket).
Changing the battery type used
DANGER
Risk of fire and explosion!
If the battery charger has not been configured for the
battery type used and, for example, an excessively
high battery capacity has been set, this may result
in excessive heating and significant gas emissions.
Oxyhydrogen gas and sulphur compounds form as a
result.
–
Observe the following conditions, which may
mean that a reconfiguration of the battery charger
is required.
The battery charger must be configured for the
battery type used. When changing the battery
type used, fleet manager access authorisation
(variant) allows the fleet manager to reconfig-
ure the battery charger if necessary.
Reconfiguration not required:
●
Changing from a lead-acid battery to a
STILL lithium-ion battery
●
Changing from one STILL lithium-ion bat-
tery to another STILL lithium-ion battery
The battery charger receives all necessary
data directly from the lithium-ion battery.

Operating
4
On-board charger
420 56388011501 EN - 05/2022 - 08