Still RX60 35-50, Оригинальное руководство пользователя

Страница: 271 / 596

Intermediate lift cut-out (variant)
This function interrupts the lifting process at
a set lift height. The intermediate lift cut-out
function is useful if the fork carriage is fre-
quently lifted to a particular lift height.
There are two options when buying the truck:
1
When buying the truck, the lift heights at
which the intermediate lift cut-out takes
effect are defined.
These lift heights are then set and activa-
ted on delivery.
2 No lift heights are defined when the truck
is bought.
The lift heights themselves are config-
ured and defined with the "Access au-
thorisation for the fleet manager". See
"Configuration by the fleet manager" in
this section.
NOTE
Check the lift heights set here before use
via the
Intermediate lift cut-out
menu.
NOTE
The fleet manager can use his access author-
isation to set the lift heights at which the in-
termediate lift cut-out takes effect. If no fleet
manager access is enabled, the authorised
service centre must set the desired lift heights.
The intermediate lift cut-out is always active
when the truck is switched on. If the function is
switched off, it is active again the next time the
truck is switched on.
During the lifting operation, the active inter-
mediate lift cut-out is indicated by the grey
symbol . This means that the fork is located
below the intervention height.
If the symbol appears in black, the fork is
just below the intervention height.

Operating
4
Lift height-dependent assistance systems
255 56388011501 EN - 05/2022 - 08