Still RX60 35-50, Оригинальное руководство пользователя

Страница: 270 / 596

Lift height display (variant)
If the truck is equipped with the optical
lift height measuring system, the current lift
height (1) appears permanently in the display-
operating unit.
The lift height displayed corresponds to the
height of the bottom edge of the fork arms. If
desired, the authorised service centre can set
a different value. If a different attachment is
installed, the authorised service centre must
adjust this value.
The system works across the entire lift range,
from ground level up to the maximum lift
height.
When properly configured, the measurement
inaccuracy is as follows:
Repeatability ±5 mm
Maximum measure-
ment inaccuracy
±45 mm
NOTE
If the prerequisites on the truck have changed,
e.g. the tyres are worn, the value displayed
for the lift height may differ more from reality.
In this case, the lift height display must be
zeroed.
–
See the section entitled "Zeroing the assis-
tance systems".
1,6
t
2,71 m
7,0°

Operating
4
Lift height-dependent assistance systems
254 56388011501 EN - 05/2022 - 08