Still RX20 14-20, Оригинальное руководство пользователя

Страница: 450 / 600

–
To start the charging process, push and
hold the charging button (8) on the truck
plug for 2 seconds.
To charge the battery carefully, the battery
charger starts a special charging characteris-
tic curve. A full charge in this condition takes
longer than a normal charging process. The
driver must monitor the charging process at
regular intervals (at least every 30 minutes). If
the battery heats up to an excessive degree
or emits a lot of gas (strong sulphur smell),
the driver must cancel the charging process
immediately. In this case, the battery is proba-
bly defective.
Compatible batteries
DANGER
Risk of fire and explosion!
If an unapproved or defective battery is used, this
can cause overloading as well as excessive gas
emissions and overheating of the battery.
–
Only use intact batteries approved by STILL.
CAUTION
Risk of damage to components.
If batteries other than those listed here are used, it
is not possible to guarantee that the batteries will not
incur damage and will charge correctly.
–
Use only the batteries listed here.
In addition to proprietary STILL lithium-ion batteries, only the following batteries may be used:
Manufacturer Designation Capacity
1)
All
2)
PzS, TCSM wet battery < 1700 Ah (48 V)
Exide TCSM gel battery < 1400 Ah (48 V)
Exide Sonnenschein PzV (Gel)
3)
< 1400 Ah (48 V)
Hawker Evolution PzV (Gel)
3)
< 1400 Ah (48 V)
Only the batteries listed here have been tes-
ted.
1)
In order to achieve the full life expectan-
cy of the battery, it is recommended that a
minimum charging current of 0.1 C (0.12 C
8
6219_003-257

Operating
4
On-board charger
434 56368011501 EN - 04/2022 - 13