Still FM-X EW Series, Оригинальное руководство пользователя

Страница: 259 / 360

Operation
4
Replacing and transporting the battery
– Use the actuating lever (joystick or fingertip
switch) to retract the reach carriage to-
gether with the battery to the drive side into
the end position.
The battery lock audibly engages. The battery
is locked. If the battery lock does not engage,
the battery was not extended by at least a third
to the load side after unlocking. Extend and
retract the battery again to lock the battery.
The acoustic warning signal stops. The driving
speed and hydraulic functions are no longer
restricted.
– After locking the battery, move the reach
carriage to the load side out of the end
position. The "lock" and "creep speed"
symbols disappear from the display.
NOTE
In normal operation, the acoustic warning
signal together with the "lock" and "creep
speed" symbols indicate that the battery lock
sensor has a mechanical defect. Have any
defects rectified by the authorised service
centre.
1 2
Adjusting the battery lock
Adjustment instructions
Battery trays for traction batteries are manu-
factured with relatively large tolerances. To
ensure that the lock of the battery frame in
which the battery sits is in good working or-
der, its bump stops must be adjusted. This
happens in the factory during commissioning.
However, if the customer procures the battery
himself or if the battery is replaced, the adjust-
ment must be carried out on site.
– For instructions of how to install and remove
the battery, as well as for how to handle
the battery, refer to the chapter entitled
"Replacing the battery using a crane".
– Unlock the battery frame and slide it out. If
necessary, use an extension cable and an
adjacent battery.
50988078001 EN - 10/2018 247