Still FM-X 10 N, Оригинальное руководство пользователя

Страница: 145 / 380

Reach-lower lock (variant)
The reach/lower lock prevents the load forks
from being lowered between the running
wheel beams for the entire time that the reach
carriage is in the retracted position. As a re-
sult, wide loads cannot accidentally come to
rest on the running wheel beams during lower-
ing and become unstable. The driver can
override the cut out by pressing the acknowl-
edge button (1) or by pressing the "F button"
(2).
Placing loads down on the ground
–
Lower the fork carriage to the interlock.
–
Extend the reach carriage in the load direc-
tion to the stop.
–
Fully lower the fork carriage.
When the reach carriage is fully extended, the
fork carriage can be lowered fully without the
lock. It is not then possible to retract the reach
carriage. This prevents the load from being
"stripped". The driver must first lift the load
"free" again (to a height greater than 400 mm)
or override the cut-out by pressing the ac-
knowledge button.
Overriding the reach/lower lock by pressing
the acknowledge button:
●
Press the acknowledge button (1) to over-
ride the cut out.
Overriding the reach/lower lock by pressing
shift button "F":
●
The adhesive label (2) indicates that the "F
button" (3) is another option that can be
used to acknowledge commands.
Move the joystick or the relevant fingertip
switch to the zero position. Within one sec-
ond, press the "F button" and release it
again to override the cut-out.
If the "F button" is not pressed and then re-
leased within one second, the default func-
tion of the F button is restored automatical-
ly.
1
3
2
3

Operating
4
Lifting
133 50988078001 EN - 11/2021 - 10