Still FM-X 10 N, Оригинальное руководство пользователя

Страница: 144 / 380

Automatic lift cut out (variant)
The automatic lift cut-out interrupts the lifting
of the load at a certain height. The height must
be set by the authorised service centre.
Intermediate lift cut-out (acknowledgea-
ble)
The intermediate lift cut-out makes frequent
approaches to a required lift height easier.
The driver can override the lift cut-out by
pressing the acknowledge button (1) or by
pressing shift key "F"(3). As soon as the fork
is lowered below the limit height, the lift cut-
out is active again. As a result, the lift cut-out
can be used in different hall areas with differ-
ent lift heights.
Overriding the lift cut out by pressing the ac-
knowledge button:
●
Press the acknowledge button (1) to over-
ride the cut out.
Overriding the lift cut out by pressing the "F
button":
●
The adhesive label (2) indicates that the "F
button" (3) is another option that can be
used to acknowledge commands.
Move the joystick or the fingertip switch to
the zero position. Within one second, press
the "F button" and release it again to over-
ride the cut-out.
If the "F button" is not pressed and then re-
leased within one second, the default func-
tion of the F button is restored automatical-
ly.
Lift cut-out limit stop (not acknowledge-
able)
The lift cut-out limit stop prevents the lift mast
being extended up to the maximum possible
lift height. This helps to prevent lift mast colli-
sions, for example, if the ceiling of the hall is
lower than the maximum lift height of the
truck.
The driver cannot cancel the lift cut-out limit
stop.
1
3
2
3

Operating
4
Lifting
132 50988078001 EN - 11/2021 - 10