3 Important safety information
ASTOTHERM PLUS Instructions for Use
9
WARNING
Risk of haemolysis!
Make sure that the infusion line is not kinked.
WARNING
Risk of air embolism!
When fluids are warmed up, it is possible that gas may evolve (bubble form).
Be aware of the potential for air emboli when using a blood and fluid warmer.
Therefore prime all filters, lines and disposable sets before starting a treat-
ment.
Make sure all connections of the complete fluid stream are fixed tightly to
prevent fluid leakages and inadvertent infusion of air into the fluid stream.
Do not warm infusions containing soluted gas (e.g. bicarbonate).
Extreme care should always be taken to ensure that a bolus o fair does not
pass to the patient.
WARNING
Risk of infection!
Use aseptic procedures.
Clean and disinfect the warmer after every use and before you return the
warmer for repairs.
WARNING
Risk of electric shock!
To avoid the risk of electric shock, this equipment must only be connected to
a supply mains with protective earth.
Do not use mains adapters that interrupt the earth conductor.
Do not open the ASTOTHERM PLUS housing.
If several pieces of equipment are combined or connected together (e.g., in
multiple socket outlets), the total leakage currents must not exceed the
allowable limits (refer to the respective national regulations). Observe the
requirements as stipulated in IEC/EN 60601-1 regarding medical electrical
systems.
All electrical installations must conform to the applicable electrical standards
and the specifications defined by the manufacturer.
Before every use, check to make sure that the ASTOTHERM PLUS is
undamaged.
The mains plug must be removed from the socket to fully disconnect the
ASTOTHERM PLUS from the mains.
