Stihl MS 661, Руководство пользователя, Страница: 12 / 138

11 MS 661, MS 661 C-M
3.4 Rewind Starter
Condition Cause Remedy
Starter rope broken Rope pulled out too vigorously as
far as stop or over edge, i.e. not
vertically Install new starter rope
Normal wear Install new starter rope
Starter rope does not rewind Rewind spring very dirty or
corroded Clean or replace rewind spring
Insufficient spring tension Check rewind spring and increase
tension
Rewind spring broken Install new rewind spring
Starter rope cannot be pulled out
far enough Spring overtensioned Check rewind spring and reduce
tension
Starter rope can be pulled out
almost without resistance
(crankshaft does not turn) Guide pegs on pawls or pawls
themselves are worn Replace pawls
Spring clip on pawl fatigued Fit new spring clip
Spring clip not installed properly Install spring clip correctly
Starter rope is difficult to pull or
rewinds very slowly Starter mechanism is very dirty Thoroughly clean complete starter
mechanism
At very low outside temperatures:
Lubricating oil on rewind spring
becomes viscous (spring windings
stick together) or moisture has got
onto the rewind spring (spring
windings frozen together) Coat rewind spring with a small
amount of standard solvent-based
degreasant (containing no
chlorinated or halogenated
hydrocarbons), then pull rope
carefully several times until normal
action is restored