Stihl MS 361, Инструкция по эксплуатации

Страница: 22 / 44

Part-time use: every six months
occasional use: annually
15 Winter Operation
15.1 Preheating the carburetor
15.1.1 At temperatures below 10°C
213BA024 KN
1
► Use the combination wrench or a screwdriver
to ease the shutter (1) out of the summer posi‐
tion
s
.
213BA025 KN
► Fit the shutter in the winter position (
r
) –
symbol
r
facing up.
Heated air is now drawn in from around the cylin‐
der to warm the carburetor – this helps prevent
carburetor icing.
► At temperatures above 20°C: Return the shut‐
ter to the summer position (
s
) to avoid
engine running problems and overheating.
15.1.2 At temperatures below -10°C
It is advisable to fit the "cover plate" kit (special
accessory) if you use your saw in extremely cold
conditions (temperatures below -10°C, in powder
or drifting snow).
If idling behavior is erratic or acceleration is poor:
► Turn the low speed screw (L) 1/4 of a turn
counterclockwise.
It is usually necessary to change the setting of
the idle speed screw (LA) after every correction
to the low speed screw (L) – see "Adjusting the
Carburetor".
► If your saw is very cold (frost or ice on
machine), start the engine and keep it at a
high idle speed (with chain brake disengaged)
until it reaches normal operating temperature.
15.2 Mounting kit
The cover plate mounting kit helps prevent snow
being sucked into the machine.
When the cover plate is fitted, the shutter must
be in the winter position.
In the event of engine running problems, first
check that the conditons for use of the cover
plate mounting kit still apply.
16 Starting / Stopping the
Engine
16.1 Positions of Master Control
lever
STOP
0
001BA140 KN
Stop 0 – engine off – the ignition is switched off.
Normal run position
F
– engine runs or can fire.
Starting throttle
n
– this position is used to
start a warm engine. The Master Control lever
moves to the normal run position as soon as the
throttle trigger is squeezed.
English 15 Winter Operation
22 0458-212-0121-C