Stihl MA02-200-0004, Инструкция по эксплуатации

Страница: 57 / 164

19.2 Chain Sprockets and Chain
Speeds
The following chain sprockets may be used:
8-tooth for .325"
–
Maximum chain speed: 30 m/s
19.3 Minimum Groove Depth of
Guide Bars
The minimum groove depth depends on the pitch
of the guide bar.
–
.325“ P: 1.6 mm
19.4 STIHL AP battery
–
Battery Technology: Lithium-ion
–
Voltage: 36 V
–
Capacity in Ah: see rating label
–
Energy content in Wh: see rating label
–
Weight in kg: see rating label
–
Permissible temperature range for operation
and storage: -10°C to +50°C
19.5 Sound Values and Vibration
Values
The K-value for the sound pressure levels is
2 dB(A). The K-value for the sound power levels
is 2 dB(A). The K-value for vibration level is
2 m/s².
STIHL recommends wearing ear defenders.
–
Sound pressure level L
pA
measured according
to EN 62841‑4‑1: 93 dB(A)
–
Sound power level L
wA
measured according to
EN 62841-4-1: 104 dB(A)
–
Vibration level a
hv
measured according to
EN 62841-4-1:
–
Control handle: 2.8 m/s²
–
Handlebar: 2.6 m/s²
The sound and vibration levels indicated were
measured according to a standardized test
method and can be used as a basis for compar‐
ing electric power tools. The actual sound and
vibration levels may vary from the values indica‐
ted, depending on the type of application. The
sound and vibration levels indicated can be used
for an initial estimate of the sound and vibration
stress. The actual sound and vibration stress has
to be estimated. The times when the electric
power tool is turned off and the times when it is
turned on but running under no load can be
taken into account in the estimate.
For information on compliance with Employers'
Vibration Directive 2002/44/EC see
www.stihl.com/vib.
19.6 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
20 Bar and Chain Combinations
20.1 STIHL MSA 300.0, MSA 300.0 C Chainsaws
Pitch Drive link
gauge/groove
width
Length Guide bar Number of
teeth, spro‐
cket nose
Number of
drive links
Saw chain
.325“ 1.3 mm
35 cm
Rollomatic E /
Light 04
10
60
67
74
81
23 RD3 Pro
(Model 3696)
23 RM Pro
(Model 3693)
23 RM3 Pro
(Model 3695)
23 RS Pro
(Model 3690)
23 RS3 Pro
(Model 3694)
40 cm
45 cm
50 cm
40 cm
Duromatik E /
Strong S
- 67
The cutting length of a guide bar depends on the chainsaw and the saw chain being used. The actual
cutting length of a guide bar may be less than the specified length.
20 Bar and Chain Combinations English
0458-009-9601-B 57