0458-766-9921-B
62
English
13 After Finishing Work
► If the limb is under tension: Make the relieving cut (1) at
the compression side and then perform bucking cut (2)
from the tension side.
Cutting thick branches
► First perform a relieving cut (2) and then a cross cut at a
distance of 20 cm (A) from the final cut (1).
► Perform a relieving cut and then finish with a cross-cut (1).
13.1 After Finishing Work
► Switch off the pole pruner, push retaining latch to position
and remove the battery.
► If the pole pruner is wet: Allow the pole pruner to dry.
► Clean the pole pruner.
► Clean the bar and chain.
► Loosen nut on the chain sprocket cover.
► Turn the tensioning screw two full turns counterclockwise.
The chain is now slack.
► Tighten down the nut on the chain sprocket cover.
► Fit the scabbard so that it completely covers the guide bar.
► Clean the battery.
14.1 Transporting the Pole Pruner
► Switch off the pole pruner, push retaining latch to position
and remove the battery.
► Fit the scabbard so that it completely covers the guide bar.
► Carry the pole pruner by the shaft with the guide bar
behind you.
► Transporting the pole pruner in a vehicle: Secure the pole
pruner to prevent turnover and movement.
14.2 Transporting the Battery
► Switch off the pole pruner, push retaining latch to position
and remove the battery.
► Make sure the battery is in a safe condition.
► Observe the following points when packing the battery:
– The packaging must be non-conductive.
– Make sure the battery cannot shift inside the packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the requirements for the transport
of dangerous goods. The battery is classified as UN 3480
(lithium-ion batteries) and has been tested in accordance
with UN Manual of Tests and Criteria, Part III, sub-section
38.3.
For transport regulations see www.stihl.com/safety-data-
sheets
13 After Finishing Work
1
2
0000-GXX-4765-A0
a
1
2
0000-GXX-4766-A0
14 Transporting
