Stihl HL 100, Инструкция по эксплуатации, Страница: 18 / 68

HL 100, HL 100 K
English
16
Controls
1 Throttle trigger lockout
2 Throttle trigger
3 Slide control
Positions of slide control
4
STOP
-
0 – engine off – the ignition is
switched off
5
F
– normal run position – the engine
is running or can start
6 START – ignition is switched on –
the engine can start
Symbol on slide control
7
h
– stop symbol and arrow. To stop
the engine, push the slide control in
the direction of the arrow on the stop
symbol (
h
) to STOP
-
0.
Starting
N
Press down the trigger lockout lever
and squeeze the throttle trigger
N
and hold them in that position.
N
Move the slide control to START
and hold it there.
N
Now release the throttle trigger,
slide control and trigger interlock in
that order. This is the starting
throttle position.
N
Set the choke knob (8):
For cold start to
g
For warm start to
e
– also use this
position if the engine has been running
but is still cold.
N
Press the manual fuel pump
bulb (9) at least five times – even if
the bulb is already filled with fuel.
N
Put the unit on the ground: It must
rest securely on the engine support
and the gearbox.
N
On units with an adjustable cutter
bar and defined transport position:
Set the cutter bar to the straight (0°)
position.
N
Remove the blade scabbard. Check
that the cutting tool is not touching
the ground or any other obstacles. If
necessary, rest the gearbox on a
raised support (e.g. mound, brick or
something similar).
N
Make sure you have a firm footing.
N
Hold the unit with your left hand and
press it down firmly – your thumb
should be under the fan housing.
NOTICE
Do not stand or kneel on the drive tube
since it will otherwise be permanently
bent and damaged.
Starting / Stopping the
Engine
3
STOP
2
5
6
4
7
002BA181 KN
START
STOP-
1
249BA057 KN
9
8
388BA039 KN