Stihl FC 111, Инструкция по эксплуатации, Страница: 18 / 88

FC 96, FC 111
English
16
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 6 in (15 cm)
N
Slide the handle to the required
position.
N
Tighten down the screw with the
combination wrench so that the
handle cannot be rotated on the
drive tube.
It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
assembled.
N
Set the throttle trigger to the full
throttle position.
N
Carefully rotate the screw in the
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another half turn in the
same direction.
N
Lay the power edger on its back so
that the blade mounting (1) faces
up.
N
Insert the stop pin (2) into the
hole (3) as far as stop – apply slight
pressure and turn back and forth
A
0000-GXX-1562-A0
Adjusting the Throttle Cable
002BA655 KN
Mounting the Cutting Blade
257BA013 KN
4
3
6
2
257BA014 KN
5