Stihl FBD-KM, Инструкция по эксплуатации

Страница: 14 / 44

FBD-KM
English
12
Have a worn depth wheel replaced by a
servicing dealer. STIHL recommends
that you have servicing and repair work
carried out exclusively by an authorized
STIHL servicing dealer.
N
The end of the thread on the
screw (1) is caulked to ensure that
the wingnut (2) does not work loose
and be lost.
A very high torque has to be applied to
remove the wingnut from the screw. If
the parts are then reassembled, the
captive function is no longer
guaranteed. In such a case have the
screw and wingnut replaced by a
servicing dealer.
Removing the skirt
N
Take out the screws (1).
N
Remove the strap (2) and skirt (3).
Fitting the skirt
N
Place the skirt (3) in position – it
must be flush with the end of the
deflector.
N
Fit the strap (2), insert the
screws (1) and tighten them down
firmly.
STIHL recommends you use only
original STIHL cutting blades – see
"Special Accessories".
WARNING
Do not attempt to straighten or weld a
worn, bent or cracked blader (1) – it may
break – always install a new blade.
WARNING
Do not resharpen the blade.
Checking Wear
Check the angle (arrow) on the blade
and the contour of the cutting edges.
Replacing the Depth Wheel
1
9924BA015 KN
2
Replacing the Skirt
3
9924BA017 KN
2
1
9924BA018 KN
3
2
1
Replacing the Cutting Blade
1
9924BA026 KN