Stihl BC 230, Инструкция по эксплуатации, Страница: 12 / 20

► Pull the starter grip quickly and allow the
starter rope to rewind several times until the
engine runs.
► Blip the throttle trigger (5).
The slide control springs (3) to position . The
engine runs at idling speed.
► If the blades rotate while the engine is idling:
Rectify the malfunction.
Idle speed adjustment is not correct.
► If the engine does not start: Prepare the
engine for the start and then try again to start
the engine.
8.4 Stopping the Engine
1
2
3
0000-GXX-6430-A0
► Release the throttle trigger (3) and lockout
lever (2).
The blades stop rotating.
► Move the slide control (1) to posi‐
tion .
The engine stops.
► If the engine does not stop:
► Move the choke lever to position .
The engine stops.
► Do not use your cultivator and contact your
STIHL servicing dealer for assistance.
There is a malfunction in the slide control.
9 Checking the Cultivator
9.1 Checking the Controls
Throttle trigger lockout and throttle trigger
► Shut off the engine.
► Attempt to pull the trigger without depressing
the lockout lever.
► If the trigger can be pulled: Do not use your
cultivator and contact your STIHL servicing
dealer for assistance.
There is a malfunction in the throttle trigger
lockout.
► Press down the throttle trigger lockout and
hold it there.
► Depress the throttle trigger.
► Release the throttle trigger and throttle trigger
lockout.
► If the trigger or trigger lockout is stiff or does
not spring back to the idle position: Do not use
your cultivator and contact your STIHL servic‐
ing dealer for assistance.
Trigger or trigger lockout is faulty.
Throttle cable adjustment
► Start the engine.
► Attempt to pull the trigger without depressing
the lockout lever.
► If the engine accelerates: Adjust the throttle
cable.
Throttle cable adjustment is not correct.
Stopping the engine
► Start the engine.
► Move the slide control to position
.
The engine stops.
► If the engine does not stop:
► Move the choke lever to position .
The engine stops.
► Do not use your cultivator and contact your
STIHL servicing dealer for assistance.
There is a malfunction in the slide control.
10 Working with the Cultivator
10.1 Adjusting Carburetor for Opera‐
tion at High Altitude
If you use the cultivator at high altitude, the
engine will not deliver optimum power. The car‐
buretor setting can be adjusted to obtain opti‐
mum engine power.
► Start the engine.
► Warm up the engine by opening and closing
the throttle for about 1 minute.
0000-GXX-3132-A0
H
NOTICE
■ If the cultivator is again used at a low altitude,
the engine may overheat.
► Carry out the standard setting.
► Rotate the high speed screw (H) clockwise
until the engine delivers optimum power.
English 9 Checking the Cultivator
12 0458-495-0121-B