Stihl ASA 85, Инструкция по эксплуатации

Страница: 18 / 224

0458-285-9721-C
16
English 12 Testing the Pruning Shears and Battery
The display shows the number of cuts that can be performed
before the next recommended service is due.
The display shows the battery’s state of charge after a few
seconds. Each bar represents 10% of the battery's capacity.
The pruning shears switch off automatically if they are not
operated for more than 10 minutes. A series of 5 short beeps
sound for 20 seconds.
► Move the on/off switch (3) to ‘OFF’ and then to ‘ON’.
The pruning shears are again ready for operation.
11.2 Switching Off the Pruning Shears
► Pull the trigger (2) and hold it there.
The cutting blade (1) closes.
NOTICE
The pruning shears can be damaged if the on/off switch is
moved to ‘OFF’ before the cutting blade is closed.
► Wait until the cutting blade is closed.
► Move the on/off switch (3) to ‘OFF’.
► Put the pruning shears in the holster.
12.1 Testing the Pruning Shears
The following tests are performed consecutively:
– Electrical connection between battery and control unit
– Electrical connection between control unit and motor
– Electrical connection between control unit and trigger
– Control unit
► Switch on the pruning shears.
► Press the control lever (2) downwards as often as
necessary until the display (1) shows ‘XXXXXX Vx.xx’.
► Depress the control lever (2) and hold it depressed until
the display (1) shows ‘TESTING’.
A rapid sequence of several beeps sound and the pruning
shears are tested.
Press the control lever (2) in any direction to end the test.
Electrical connection between battery and control unit
BATT: I I I I I I
0000-GXX-4088-A0
2
3
1
0000-GXX-4087-A0
12 Testing the Pruning Shears and
Battery
2
1
XXXXXX Vx.xx
TESTING
0000-GXX-4089-A0
BATT OK
BATT KO
0000-GXX-4090-A0