STIHL 019 T
13
4.2
Assembly
• Take out screws from underside of
engine.
• Check that grommet is properly
seated in the engine housing.
• Place throttle cable in the
grommet.
- Fit top and bottom engine
mounting screws and torque
down to 8.0 Nm (5.9 Ibf.ft).
• Remove engine sideways from
housing.
• Throttle cable sleeve must locate in
retainer in air baffle.
• Push grommet, ledge facing up,
over the lugs of the intake pipe.
• Fit engine and position throttle
cable in the handle at the same
time.
- Push throttle cable into retainer in
handle.
• Push grommet with intake pipe into
the engine housing until the ledge
butts against the engine housing.