STIEBEL ELTRON DHE 18 AU, Эксплуатация и установка, Страница: 15 / 24

iNSTAllATiON
installation alternatives
EN
GL
ISH
www.stiebel-eltron.com DHE AU | 15
13.2 Electrical connection on unfinished walls from
below with short power cable
D
00000
60
38
7
f f
Reposition the mains terminal further downwards. To do this,
undo the fixing screw. Secure the mains terminal in place.
13.3 Electrical connection on finished walls
Note
This type of connection changes the IP rating of the ap-
pliance.
f f
Change the type plate. Cross out "IP 25" and mark
the box "IP 24". Use a ballpoint pen to do this.
A
30
D
00000
76
50
6
1
1 Cable grommet
Electrical connection on finished walls Dimension A
Positioned in lower section of appliance 160
Positioned in upper section of appliance 110
f f
Prepare the power cable. Fit the cable grommet.
!
Material losses
If you break out the wrong knock-out in the back panel/
appliance cover by mistake, you must use a new back
panel/appliance cover.
f f Cleanly cut and break out the required cable entries from the
back panel and appliance cover (for the positions, see chap-
ter "Specification / Dimensions and connections"). Deburr any
sharp edges with a file.
f f
Route the power cable through the cable grommet.
f f Connect the power cable to the mains terminal.
13.4 Water installation on unfinished walls
12
D
00000
53
31
9
f f
Seal and screw in the twin nipples (not included in standard
delivery).
D
00000
41
72
4
2
3
1
3
1 Tee for cold water
2 Tee for domestic hot water
3 Cap
f f Fit the water connections.
D
00000
43
29
1
f f Fit the strainer and the plastic profile washer in the tee for
the cold water inlet.
!
Material losses
The strainer must be fitted for the appliance to function.
f f
When replacing the appliance, check that the strain-
er is present.
f f Screw the connection pipes from the appliance to the tee.
f f Open the shut-off valve in the cold water inlet line.
D
00000
53
27
5
1
1 Diffuser on lower back panel
f f
Fit the lower back panel section into the back panel. Check
that both locking tabs are engaged.
f f Align the mounted appliance by undoing the fixing toggle,
aligning the power supply and back panel, and then re-tight-
ening the fixing toggle. If the back panel does not sit flush
against the wall, you can secure the appliance at the bottom
with an additional screw.
!
Material losses
The cover plate of the lower back panel section must not
bend when installed.