STIEBEL ELTRON DHE 18 AU, Эксплуатация и установка, Страница: 13 / 24

iNSTAllATiON
Commissioning
EN
GL
ISH
www.stiebel-eltron.com DHE AU | 13
11. Commissioning
11.1 Preparation
Internal anti-scalding protection via jumper slot
43 °C
Tmax
D
00000
77
02
0
1
1 Jumper for anti-scalding protection setting
Jumper position Description
43 °C
Tmax Factory setting (60 °C)
No jumper Limited to 43 °C
f f
Install the "Anti-scalding protection setting" jumper in the
required position on the top pin strip.
CAUTION Burns
If the appliance is supplied with preheated water, the
internal anti-scalding protection may be exceeded.
In this case, limit the temperature with an upstream cen-
tral thermostatic valve.
11.2 Initial start-up
≥ 60 s
D
00000
53
27
7
f f Open and close all connected draw-off valves several times,
until all air has been purged from the pipework and the
appliance.
f f Carry out a tightness check.
D
00000
53
27
8
f f
Activate the safety switch by firmly pressing the reset button
(the appliance is delivered with the safety switch disabled).
D
00000
73
19
8
f f
Connect the programming unit connecting cable to the PCB.
Note
For undersink installation, the appliance cover should be
turned the other way up for easier operation; see chapter
"Installation alternatives / Rotated appliance cover".
Fit the appliance cover
D
00000
40
77
7
1
2
3 4
1 Pipe knock-out
2 Cover guides
3 Back panel guides
4 Fixing screw (not part of the standard delivery)
f f Cleanly cut or break out the knock-out openings in the appli-
ance cover. If necessary, use a file.
!
Material losses
If you cut open the wrong knock-out in the appliance
cover by mistake, you must use a new appliance cover.
Note
You can compensate for a slight connection pipe offset
using the tabs on the cover guides. If the connection pipes
are offset, do not fit any back panel guides.
f f
When installing connection pipes without offset, break off
the tabs on the cover guide pieces.
f f
Click the cover guides into place in the openings.
f f Position the back panel guides on the extensions. Push them
together. Then push the guides against the back panel as far
they will go.
D
00000
53
28
0
f f Hook the appliance cover at the top rear into the back panel.
Pivot the appliance cover downwards. Check that the appli-
ance cover is securely seated both top and bottom.
f f Secure the appliance cover with the screw.
f f
Fit the fascia to the appliance cover.
f f
Remove the protective film from the user interface.