STIEBEL ELTRON DHE 18 AU, Эксплуатация и установка, Страница: 11 / 24

iNSTAllATiON
installation
EN
GL
ISH
www.stiebel-eltron.com DHE AU | 11
10. Installation
factory settings DHE 18 AU DHE 27 AU
Internal anti-scalding protection Tmax (= 60 °C) Tmax (= 60 °C)
Standard installation DHE 18 AU DHE 27 AU
Electrical connection from below on
unfinished walls
x x
Water connection, installation on
finished walls
x x
For further installation options, see chapter "Alternative instal-
lation methods".
10.1 Standard installation
Note
This type of connection changes the IP rating of the ap-
pliance.
f f
Change the type plate. Cross out "IP 25" and mark
the box "IP 24". Use a ballpoint pen to do this.
Opening the appliance
D
00000
53
27
1
f f
Open the appliance by holding the fascia at the side and pull-
ing forwards away from the appliance cover. Undo the screw.
Pivot open the appliance cover.
D
00000
53
27
2
f f Remove the back panel by pressing the two locking tabs and
pulling the lower back panel section forwards.
Preparing the power cable on unfinished walls, for connection
from below
160
30
D
00000
53
27
3
1
1 Cable entry installation aid
f f
Prepare the power cable.
Fitting the wall mounting bracket
D
00000
59
69
4
f f Mark out the holes for drilling using the installation tem-
plate. If the appliance is to be installed on finished walls, also
mark out the fixing hole in the lower section of the template.
f f Drill the holes and secure the wall mounting bracket at 2
points using suitable fixing materials (screws and rawl plugs
are not part of the standard delivery).
f f Fit the wall mounting bracket.
Preparing the water connection
!
Material losses
Carry out all water connection and installation work in
accordance with regulations.
D
00000
41
72
0
f f
Remove the caps from the tees.
f f Fit the plugs and the extensions with gaskets.
D
00000
41
72
1
f f Fit the strainer in the tee for the cold water inlet.
!
Damage to the appliance and environment
The strainer must be fitted for the appliance to function.
f f
When replacing the appliance, check that the strain-
er is present.