STIEBEL ELTRON DHE 18 AU, Эксплуатация и установка, Страница: 10 / 24

iNSTAllATiON
Appliance description
10 | DHE AU www.stiebel-eltron.com
8. Appliance description
8.1 Standard delivery
The following are delivered with the appliance:
- Wall mounting bracket
- Installation template
- 2 plugs
- 2 extensions
- 2 caps
- 2 tees
- 8 flat gaskets
- Strainer
- Plastic profile washer
- Plastic connection pieces / installation aid
- Cover and back panel guides
- Jumper for internal anti-scalding protection
8.2 Accessories
Wireless remote control
- FFB 4 Set AP
9. Preparation
9.1 Installation site
!
Material losses
Install the appliance in a room that is free from the risk
of frost.
f f Always install the appliance vertically and near the draw-off
point. For horizontal installation, see chapter "Installation
alternatives / Horizontal installation of the appliance".
The appliance is suitable for undersink and oversink installation.
Undersink installation
D
00000
56
24
2
1
2
1 Cold water inlet
2 DHW outlet
Oversink installation
D
00000
57
03
0
1 2
1 Cold water inlet
2 DHW outlet
Note
f f
Mount the appliance on the wall. The wall must have
sufficient load bearing capacity.
9.2 Minimum clearances
≥50 ≥50
≥90
≥90
D
00000
60
80
9
f f
Maintain the minimum clearances to ensure trouble-free op-
eration of the appliance and facilitate maintenance work.
9.3 Water installation
f f
Flush the water line thoroughly.
Fittings
Use appropriate pressure taps. Open vented taps are not per-
missible.
Permissible water line materials
- Cold water inlet line:
Pipes made from galvanised steel, stainless steel, copper or
plastic
- DHW outlet line:
Pipes made from stainless steel, copper or plastic
!
Material losses
If plastic pipework systems are used, take into account
the maximum inlet temperature and the maximum per-
missible pressure.
Flow rate
f f
Ensure that the flow rate for switching on the appliance is
achieved.
f f
If the required flow rate is not achieved when the draw-off
valve is fully open, increase the water line pressure.