Technical Service 1-800-992-1180
www.stifirestop.com
EZ-Path® Smoke & Acoustical Pathway
ZIS1086 • 03/2014
Installation in walls for new cabling installations. Installation is easily and
quickly accomplished using the following steps:
1. Locate center
2. Drill 4” diameter hole using a circular hole saw (see fig.1)
3. Using outer sleeve as guide, insert in opening and locate the flange
mounting holes. Remove sleeve. (see fig.2)
4. Using the hardware supplied, drill appropriate size hole and install
anchor. (see fig.3)
5. Insert inner sleeve and secure to wall. Be careful not to over tighten.
(see fig.4)
6. On the opposite side of the wall repeat steps 1 - 4 and install the
outer sleeve.
7. Apply wall labels after installation.
Note: When installing NEZ33 the EZ-Path® logo needs to be facing you in the upright
position and the arrows should be pointing to the top and bottom of the device. For
vertical installations, horizontal supports should be installed.
INSTRUCTION SHEET
SMOKE & ACOUSTICAL PATHWAY
SINGLE DEVICE INSTALLATION
CATALOG NUMBER - NEZ33
Fig. 2
Fig. 3
Fig. 4
LIMITED WARRANTY: STI warrants that its products will be free of defects for one year
from the date of purchase. In the event a product does not conform to this warranty, the
sole and exclusive remedy is, at STI’s option, replacement of the product or refund of
the purchase price. The warranty provided herein shall be void and of no effect in the
event that the product is not installed in accordance with STI’s published instructions, listed
systems and applicable building and safety codes. THIS WARRANTY IS IN LIEU OF ALL
OTHER REPRESENTATIONS AND EXPRESSED OR IMPLIED WARRANTIES (including
the implied warranties of merchantability or fitness for a particular use) AND UNDER NO
CIRCUMSTANCES SHALL STI BE LIABLE FOR ANY DIRECT, INDIRECT, SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES OR LOSSES, INCLUDING, WITHOUT
LIMITATION, ANY LOSS OF REVENUE, PROFIT OR USE. Prior to use, the user shall
determine the suitability of the product for its intended use, and the user assumes all risks
and liability for subsequent use. No person other than an officer of STI is authorized to bind
STI to any other warranty for any product for which this warranty is issued.
MADE IN THE USA – © 2014 SPECIFIED TECHNOLOGIES INC.
Specified Technologies Inc. • Somerville NJ 08876 USA • Phone: 800.992.1180
Fig. 1
ZIS1086 NEZ.indd 1
3/24/14 2:59 PM
