Stewart Golf X Series, Руководство пользователя

Страница: 4 / 11

6 7
PUTTING AWAY
Prior to folding, clear any debris from the trolley using compressed air or a soft brush or
cloth ( never use water). Pay particular attention to the base of the main support arms
for small stones or grit. See the FAQ for a cleaning guide.
1. Remove one side of the top bungee and lift your bag up & away from the machine.
The bottom bungee will release automatically.
2. Remove the front cover, disconnect and remove the battery and replace the front
cover.
3. Release both bottom clips simultaneously by pressing the clips with your thumbs.
Slowly lower the main support until the top bag support comes to rest on the
chassis.
4. Whilst supporting the handle, release the top clip and lower the handle until it
comes to rest on the rear cover. Do not ‘drop’ the handle or main support.
5. Lift the X10 Remote in to your car using the lifting points specified.
WARNING:
Always ensure that your X10 Remote is turned OFF at the switch or disconnected
completely when not in use. Leaving it
ON
or connected could drain the battery
totally and risk irrecoverably damaging it.
Turning OFF or disconnecting the battery will ensure that the trolley is not
accidentally activated in transit.
You may choose to remove the battery prior to folding to enable you to charge it.
In any case, it is good practice to always turn the switch to the OFF (O) position
when not in use.
6
FITTING YOUR GOLF BAG
1. Stand the base of your golf bag on the front chassis.
2. Ensure the bag cradle is fully lowered, then lean the golf bag back until it rests on
the silicone bag cushion.
3. Pull the upper bungee around the golf bag evenly and fix.
4. Pull the lower bag strap over the bottom of the bag using the handle.
Note: The X10 Remote has been optimised for use with a cart or tour style bag weighing
14kg (31lbs). Please refer to page 1 for more information.
SETTING UP
1. When removing the X Series from the car, only lift from the two lifting points. These
are the stabiliser and under the front of the chassis (parts 9 and 16). Lifting from
other parts of the trolley cover could cause unintended damage that will not be
covered under warranty.
2. To unfold, simply grip the handle and pull it towards you. The top & bottom clips will
snap into place automatically.
3. To remove the front cover, hold the two ‘S’ clips (part 10), apply slight outward
pressure and lift.
4. Insert the battery into the tray and secure with the strap. Connect the battery to the
electronics box.
5. Replace the front cover by aligning the two lugs on the straight edge with the
corresponding gaps in the rear cover, and pivot in to place. Ensure the front of the
cover is behind the small bump near the lower bag stay, apply downward pressure
to the ‘S’ clips until the cover is secured.
6. Turn the on/off switch to ‘ON’ (I) and wait for the blue light to flash. Press the
bluetooth on/off button on the handset for 1 second to switch the handset on. When
both blue lights are constantly illuminated, the bluetooth connection is established.