Stewart Filmscreen Cabaret, Руководство пользователя

Страница: 10 / 37

Stewart Filmscreen
– Cabaret
10
WALL MOUNT
Professional mounting techniques should be used. Stewart Filmscreen cannot be liable for
substandard or faulty installations. Failure to comply with the instructions and guidance
contained in this manual may result in voiding your warranty .
1. Identify the location of wall studs where you can
secure the wall mounts.
2. Use a level to accurately position the wall mounts
on the wall (see Figure 7), and make certain that
both wall mounts are within 12 inches from either
edge of the case. This will prevent the case from
tilting to either side.
3. Drill holes through the wall mounts into the studs.
4. Use 3 ½
” screws to secure the wall mounts to the
wall studs.
a.
Note: These are heavy units. This screen
must be mounted to studs or onto a wall
with a continuous plywood sheath below the
surface treatment (see Figure 7).
Check to make sure the wall mount is level.
5. Carefully lift and hook the channels on the back of the
housing onto the wall mounts (see Figure 8).
6. For the minimum clearance dimensions, (see figure 9).
⚠
CAUTION
Be careful not to touch or scratch the viewing surface.
Ensure that the wall surface is level and free of undulations. Use shimming if
necessary.
This screen is too heavy to be mounted with molly or any other type of expanding
wall anchors. They will pull away and fall if mounted to drywall.
Figure 7: Wall mounts leveled
and attached to two or more wall
studs
Figure 8: Back part of case
hanging off wall mount