S -
22
| English
English |
S -
23
Adjusting the STEVENS Bicycle to the Rider
Your body height and proportions are decisive for the frame size of your
STEVENS bicycle. Make particularly sure there is enough space between your
crotch and the top tube so that you do not hurt yourself, if you have to get off your
bike quickly.
By choosing a specific type of bicycle you roughly determine the posture you
will be riding in. However, some components of your STEVENS bicycle are espe-
cially designed so that you can adjust them to your body proportions up to a
certain degree. This includes the seat post, the handlebar and stem as well as the
brake levers or brake levers/shifters.
As these adjustments require know-how, experience, appropriate tools and
a certain amount of skill, you should restrict yourself to the adjustment of the
seating position. Ask your STEVENS dealer for the correct seating position or if you
want something changed. They will see to your wishes the next time you leave the
STEVENS bicycle at the workshop, e.g. for the first inspection.
After any adjustment/assembly work, be sure to make a short functional check
as described in the chapter
“Before Every Ride”
and do a test ride on your
STEVENS bicycle in an area free of traffic.
Danger:
If you have a very small frame, there may be the danger of your foot
colliding with the front wheel. Therefore, Make sure that your cleats are
properly adjusted.
Danger:
All tasks described in the following require the know-how of a mechanic
and appropriate tools. Make it a rule to tighten the bolted connections
always with greatest attention. Increase the torque values bit by bit and
check the fit of the component in between. Use a torque wrench and do
not exceed the maximum torque values! You find them on the components
themselves and/or in the chapter
“Recommended Torque Settings”
.
Note:
If sitting on the saddle causes you trouble, e.g. because it numbs your
crotch, this may be due to the saddle. Your STEVENS dealer has a very
wide range of saddles available and can offer advice on position.
Danger:
When replacing the sad-
dle, Make sure that the
saddle rail is compatible
with the seat post. If
you are in doubt or if
you have any questions,
contact your STEVENS
dealer.
Note:
The seating position
depends highly on how
you want to use the
STEVENS bicycle. Ask
your STEVENS dealer or
your trainer for help. The
advices given below are
suitable for typical road
racing bicycles.
Legal Requirements for Riding on Public Roads
If you want to use your STEVENS bicycle for riding on public roads, it has to be
equipped according to the regulations of the respective country.
Pay particular attention to your STEVENS bicycle being equipped with the
required set of lights and reflectors.
Ask your STEVENS dealer to inform you about the regulations in force in the
country where you use your STEVENS bicycle. Make yourself familiar with the road
traffic rules for riding on public roads and off-road.
Note:
You find more important
tips on cycling in the
chapter
“General Safety
Instructions”
.
Danger:
For your own safety, be
sure to switch on the
light as soon as dusk
sets in.
Danger:
Keep the lighting set
clean and check its
functioning at regular
intervals.
Note:
If you want to use your STEVENS bicycle for riding on public roads, it has
to be equipped according to the regulations of the respective country. Ask
your STEVENS dealer about the regulations in force in your country or in
the country where you intend to use the STEVENS bicycle.
Note:
When riding on public roads cyclists must in general observe the same
traffic rules as car drivers. Make yourself familiar with the road traffic rules
of your country.
